New 988K XE Wheel Loader for Sale

988K XE Wheel Loader

Net Power

541 HP
Engine Model

Cat® C18 ™
Bore

5.7 in
Stroke

7.2 in

Engine

Net Power: 541 HP
Engine Model: Cat® C18 ™
Bore: 5.7 in
Stroke: 7.2 in
Displacement: 1105 in³
Rated Speed: 1,700 rpm
Emissions: U.S. EPA Tier 4 Final/EU Stage V
Gross Power: 580 HP
Net Power: 541 HP
Peak Power Speed: 1,500 rpm
Peak Power Speed: 580 HP
Peak Power Speed: 588 HP
Peak Power Speed: 541 HP
Peak Torque: 2104 ft·lbf
Torque Rise: 58%

Operating Specifications

Operating Weight: 116362 lb
Rated Payload: 12.5 ton (US)
Rated Payload: 16 ton (US)
Bucket Capacity Range: 4.7-13 m3 (6.2-17 yd3)
Rated Payload: 12.5 t
Rated Payload: 16 t
Rated Payload: 12.5 t
Rated Payload: 16 t
Operating Weight: 119618 lb
Operating Weight: 116362 lb

Transmission

Transmission Type: Cat switched reluctance electric drive
Forward 1: 4.3 mile/h
Forward 2: 7 mile/h
Forward 3: 13.8 mile/h
Forward 4: 20 mile/h
Reverse 1: 4.3 mile/h
Reverse 2: 7 mile/h
Reverse 3: 17.5 mile/h

Hydraulic System - Lift/Tilt

Lift Cylinder: 8.7 in
Lift Cylinder: 41.3 in
Lift: EH-Positive Flow Control, Flow Sharing
Lift: Variable displacement piston
Maximum Flow at 1: 153 gal/min
Relief Valve Setting: 4757 psi
Tilt Cylinder: 8.7 in
Tilt Cylinder: 27 in

Service Refill Capacities

Fuel Tank: 147 gal (US)
Transmission: 16 gal (US)
Cooling System: 30 gal (US)
Cooling Systems: 8 gal (US)
Diesel Exhaust Fluid Tank: 8.7 gal (US)
Differential: 49 gal (US)
Differential: 49 gal (US)
Engine Crankcase: 16 gal (US)
Hydraulic System: 126 gal (US)
Note: All non-road Tier 4 Final/Stage IV diesel engines are required to use: – The machine has the flexibility to run on either ultra-low-sulfur diesel fuel (ULSD with 15 ppm of sulfur or less) or up to B20 biodiesel when feedstock meeting ASTM D7467 specific

Buckets

Bucket Capacities: 4.7-13 m3 (6.2-17 yd3)

Axles

Front: Fixed
Rear: Trunnion
Oscillation Angle: 13°

Brakes

Brakes: ISO 3450:2011

Hydraulic System - Steering

Maximum Flow at 1: 71.3 gal/min
Steering Cut Off Pressure: 4351 psi
Steering Cycle Times: 3.4 s
Steering Cycle Times: 5.6 s
Steering System: Pilot, load sensing
Steering System: Piston, variable displacement
Total Steering Angle: 86°
Steering: ISO 5010:2007

Hydraulic Cycle Times

Dump: 2.2 s
Lower Float Down: 3.5 s
Rack Back: 4.5 s
Raise: 8 s
Total Hydraulic Cycle Time: 18.2 s

Sound Performance - Tier 4 Final/Stage IV

Machine Sound Level: 109 dB(A)
Operator Sound Level: 72 dB(A)
Note: The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan speed.
Note: Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.
Note: The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan speed.

Air Conditioning System

Air Conditioning: The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equivalent of 2.574 metric tonnes.

Dimensions (Approximate) - High Lift

B: 19.3 ft
Clearance at Maximum Lift: 12.7 ft
Front Axle Centerline to Bucket Tip: 15.9 ft
Ground to Bumper Clearance: 3.1 ft
Ground to Center of Axles: 3.2 ft
Ground to Lower Hitch Clearance: 1.9 ft
Ground to Top of Exhaust Stacks: 14.8 ft
Ground to Top of Hood: 10.9 ft
Ground to Top of ROPS: 13.7 ft
Maximum Overall Height: 25.8 ft
Maximum Overall Length: 41.3 ft
Note: Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height.
Reach: 7 ft
Rear Axle: 10.5 ft
Wheel Base: 14.9 ft

Dimensions (Approximate) - Standard Lift

B: 18 ft
Clearance at Maximum Lift: 11.3 ft
Front Axle Centerline to Bucket Tip: 14.7 ft
Ground to Bumper Clearance: 3.1 ft
Ground to Center of Axles: 3.2 ft
Ground to Lower Hitch Clearance: 1.9 ft
Ground to Top of Exhaust Stacks: 14.8 ft
Ground to Top of Hood: 10.9 ft
Ground to Top of ROPS: 13.7 ft
Maximum Overall Height: 24.5 ft
Maximum Overall Length: 40 ft
Note: Specs are calculated with 6.9 m3 (9.0 yd3) rock bucket and Michelin XLDD2 with 978 mm (3.2 ft) centerline of rear axle height.
Reach: 6.8 ft
Rear Axle: 10.5 ft
Wheel Base: 14.9 ft

Operator's Cab

ROPS: ROPS/FOPS meet ISO 3471:2008 and ISO 3449:2005 Level II standards

NOTE
- Standard and optional equipment may vary. Consult your Cat dealer for details.
ELECTRICAL
- Alarm, back-up
- Alternator, single 150 amp
- Batteries, dry
- Converter, 10/15 amp, 24V to 12V
- Lighting system (halogen, work lights, access and service platform lighting)
- Starting and charging system, 24V
- Starter emergency start receptacle
- Starter lockout in bumper
- Transmission lockout in bumper
- Hazardous voltage lamp
OPERATOR ENVIRONMENT
- Graphical Information Display, displays real time operating information, performs calibrations and customizes operator settings
- Air conditioner
- Cat Detect Vision, rear vision camera system
- Cab, sound suppressed and pressurized, integrated rollover protective structure (ROPS/FOPS) radio ready for entertainment, includes antenna, speakers and converter (12‑volt 5-amp) and power port
- Controls, lift and tilt function
- Heater, defroster
- Horn, electric
- Instrumentation, gauges
  – Coolant temperature
  – Engine hour meter
  – Hydraulic oil temperature
  – Power train oil temperature
- Light, cab, dome
- Lunchbox, beverage holders
- CB radio-ready
- Mirrors, rearview (externally mounted)
- Rimpull Control System
- Seat, Cat Comfort Series III, heated and ventilated, air suspension, six-way adjustable
- Seat belt minder
- Seat belt, retractable, 76 mm (3 in) wide
- STIC Control System
- UV glass
- Virtual gear indicator
- Vital Information Management System (VIMS) with Graphical Information Display: External Data Port, Customizable Operator Profiles, Cycle Timer, Integrated Payload Control System
- Wet-Arm wipers/washers (front and rear)
  – Intermittent front and rear wipers
- Lights, directional
POWER TRAIN
- Brakes, oil-cooled, multi-disc, service/secondary
- Case drain screens
- Electro hydraulic parking brake
- Engine, C18 MEUI diesel, turbocharged/aftercooled
- Ground level engine shutoff
- Turbine precleaner, engine air intake
- Radiator, Aluminum Modular Radiator (AMR)
- Starting aid, ether, automatic
- Throttle lock, electronic
- Manual switch and automatic fuel priming
- Cat Production Measurement ready
- Cat SR Generator/Pump Drive
- Cat SR Drive Motor
- Cat Integrated Powered Electronics
- Automatic retarding controls
OTHER
- Automatic bucket lift kickout/positioner
- Base machine price includes a rim allowance
- Hydraulically driven demand fan
- Couplings, Cat O-ring face seals
- Doors, service access (locking)
- Ecology drains for engine, radiator, hydraulic tank
- Fuel tank, 555 L (147 gal)
- Hitch, drawbar with pin
- Hoses, Cat XT^™
- Hydraulic, steering and brake filtration/screening system
- Cat Clean Emission Module
- Oil sampling valves
- Premixed 50 percent concentration of extended life coolant with freeze protection to –34° C (–29° F)
- Rear access to cab and service platform
- Steering, load sensing
- Toe kicks
- Vandalism protection caplocks

NOTE
- Standard and optional equipment may vary. Consult your Cat dealer for details.
POWER TRAIN
- –50° C (–58° F) antifreeze
- Engine oil change system, high speed, Wiggins
- Engine block heater 120V or 240V
- High ambient cooling – software
- Cat Production Measurement
- Crankcase guard
OPERATOR ENVIRONMENT
- Cab precleaner
- AM/FM/CD/MP3 radio
- Satellite Sirius radio with Bluetooth^®
- LED warning strobe
- Window pull down visor
- Handrail mounted mirrors
MISCELLANEOUS ATTACHMENTS
- Front and rear roading fenders
- Fast fill fuel system (Shaw-Aero)
- Cold Weather Starting (extra starter plus two batteries)
- Aggregate Handler
- Tire Pressure Monitoring System