
Diesel Generator Sets
C18 Generator Set
-
Maximum Rating715 kVA
-
Minimum Rating550 kVA
-
EmissionsLow Fuel, EU Stage IIIA
-
Voltage380 to 415 Volts
Generator Set Specifications
- Maximum Rating
- 715 kVA
- Minimum Rating
- 550 kVA
- Emissions
- Low Fuel, EU Stage IIIA
- Voltage
- 380 to 415 Volts
- Frequency
- 50 Hz
- Speed
- 1500 rpm
- Duty Cycle
- Standby, Prime
Engine Specifications
- Engine Model
- C18 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
- Bore
- 5.71 in
- Stroke
- 7.2 in
- Displacement
- 1106.4 in³
- Compression Ratio
- 14.5:1
- Aspiration
- Air to Air Aftercooled
- Fuel System
- Electronic unit injection
- Governor Type
- Ademâ„¢A4
- Bore
- 145 mm (5.71 in)
- Displacement
- 18.13 L (1106.36 in3)
- Stroke
- 183 mm (7.2 in)
Generator Set Dimensions
- Length
- 218.5 in
- Length
- 218.5 in
- Width
- 80.9 in
- Height
- 107.8 in
-
Air System
- Air Cleaner, light duty
- Turborcharger
-
Air Inlet
- Air Cleaner
-
Control Panel
- EMCP 4.2
- EMCP 4 Genset Controller
-
Cooling
- Package mounted radiator
-
Cooling System
- Coolant drain line with valve
- Fan drive, battery charging alternator drive
- Radiator and cooling fan with guard
- Caterpillar Extended Life Coolant
-
Exhaust
- Exhaust flange outlet
-
Exhaust System
- Stainless steel exhaust flex, gaskets, raincap and SAE exhaust flange for customer use; shipped loose
-
Fuel System
- Standard open set fuel tank / base supplied Base, formed steel with single wall integral 8-hour fuel tank
-
Fuel
- Fuel priming pump
- Secondary fuel filter
- Primary fuel filter with integral water separator
-
Generator
- Matched to the performance and output characteristics of Cat engines
- IP23 Protection
- Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
-
Generator and Attachments
- Segregated low voltage (AC / DC) wiring panel
- Power center, IP22
- Optional LC frame generator - IP23 Protection,
- Mandatory Option Rear circuit breaker, IEC, 3 pole, mounted in power center
- Integrated Voltage Regulator
- A frame generator - IP21 Protection
-
Governing System
- Cat Electronic Governor (ADEM A4)
-
Power Termination
- Bus Bar
-
Lube System
- Oil drain valves
- Lubricating oil
-
Mounting System
- Captive linear vibration isolators between base and engine-generator includes lifting provisions and termination points for coolant and lube oil drain lines
-
Starting / Charging
- 24 Volt battery with rack and cables
-
Starting/Charging
- 24 volt starting motor
- Batteries
-
Mounting
- Rubber vibration isolators
-
General
- Engine and alternator pre-paint, Caterpillar Yellow
- Paint - Caterpillar Yellow except rails and radiators gloss black
-
Certifications
- Global
- European Certifications - EU certificate of conformance
-
Exhaust
- Industrial, Residential, Critical Mufflers
-
Air Inlet System
- Dual element air cleaner
- Single element air cleaner
-
Generator
- Oversize and premium generators
- Excitation: [ ] Permanent Magnet Excited (PM) [ ] Internally Excited (IE)
- Anti-condensation heater
-
Power Termination
- Circuit breakers, IEC compliant
- Circuit breakers, UL listed
-
Circuit Breakers
- 4 Pole (IEC-100% rated) - package mounted
- 3 Pole (IEC-100% rated) - package mounted
- Pad-lockable device
- 4 Pole (IEC-100% rated) - motorized
- Power terminal strips
- 3 Pole (IEC-100% rated) - motorized
-
Control Panel
- EMCP 4.4
-
Control Panels
- Local & remote annunciator modules
- Digital I/O module
- Load share module
- EMCP (4.2) (4.3) (4.4)
- Remote monitoring software
-
Control System
- Local alarm modules
- Control panel protective devices
- Remote annunciator modules
- Volt free contacts
-
Cooling System
- Radiator duct flange
-
Enclosures
- Sound attenuated enclosures
-
Starting/Charging
- Heavy-duty starting system
- Battery chargers
- Charging alternator
- Oversize batteries
- Jacket water heater
-
Exhaust System
- Elbow Kit
- Mufflers, End in / End out
- Manifold and turbocharger guard
- Engine mounted muffler
- Flange groups; 8 and 10 inch weld flanges and gaskets
-
Fuel System
- Integral -Duel wall fuel tank bases
- Manual fuel transfer system
- Fuel transfer system
-
General
- Integral & sub-base UL listed dual wall fuel tanks
- UL 2200 package
- Narrow, Wide or Skid Base
- Enclosures: sound attenuated, weather protective
- Sound attenuated, weather protective or high ambient weather protective enclosure
- EEC Declaration of Conformity
- Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
- The following options are based on regional and product configuration:
- Single or dual wall sub-base fuel tanks
- Automatic transfer switches (ATS)
- CSA Certification
- EU Certificate of Conformance (CE)
- Single or dual wall integral fuel tanks
-
Generator and Attachments
- A frame CIP generator
- LC frame generator
- Permanent magnet excitation
- LC frame oversize generator
- Space heaters
- Ingress protection
- LC frame CIP generator
- A frame oversize generator
-
Lube System
- Manual sump pump
-
Mounting System
- Narrow skid base
-
Starting / Charging System
- 5 Amp battery charger
- Jacket water heater
- Battery disconnect switch