Piscataway Campus
732-885-5555
Bensalem Campus
877-726-7663

Diesel Generator Sets

C18 Generator Set

  • Minimum Rating
    550 kVA
  • Maximum Rating
    715 kVA
  • Emissions
    Low Fuel, China Nonroad III Emis Stds
  • Voltage
    380 to 415 Volts
Generator Set Specifications
Minimum Rating
550 kVA
Maximum Rating
715 kVA
Emissions
Low Fuel, China Nonroad III Emis Stds
Voltage
380 to 415 Volts
Frequency
50 Hz
Speed
1500 rpm
Duty Cycle
Standby, Prime
Engine Specifications
Engine Model
C18 ATAAC, I-6, 4-Stroke Water-Cooled Diesel
Bore
5.71 in
Stroke
7.2 in
Displacement
1106.36 in³
Compression Ratio
14.5:1
Aspiration
Air to Air Aftercooled
Fuel System
Electronic unit injection
Governor Type
Ademâ„¢A4
Bore
145 mm (5.71 in)
Displacement
18.13 L (1106.36 in3)
Bore
5.71 in
Stroke
Stroke
7.2 in
Exhaust Flange Size
203.2 mm (8.0 in)
Aspiration
Air to Air Aftercooled
Fuel System
Electronic unit injection
Stroke
183 mm (7.2 in)
Generator Set Dimensions
Length
162.4 in
Width
78.3 in
Height
75 in
  • Air Inlet System
    • Turbocharger
    • Light duty air cleaner
    • Aftercooler core
  • Air Inlet
    • Air Cleaner
  • Control System
    • EMCP 4.2
  • Exhaust
    • Exhaust flange outlet
  • Cooling
    • Coolant drain line with valve
    • Caterpillar extended life coolant
    • Fan drive, battery charging alternator drive
    • Radiator and cooling fan with guard
  • Exhaust System
    • Stainless steel exhaust flex gaskets, raincap and SAE exhaust flange for customer use; shipped loose
  • Fuel
    • Secondary fuel filter
    • Fuel priming pump
    • Primary fuel filter with integral water separator
  • Fuel System
    • Standard 8 hour open set fuel tank
  • Generator
    • IP23 Protection
    • Load adjustment module provides engine relief upon load impact and improves load acceptance and recovery time
    • Matched to the performance and output characteristics of Cat engines
  • Generator and Attachments
    • Segregated low voltage (AC/DC) wiring panel
    • Integrated Voltage Regulator
    • A frame generator - IP21 protection
    • Integrated Voltage Regulator
    • Mandatory Option circuit breaker, IEC, 3 pole, mounted in power centre
    • Power center, IP22
    • Matched to the performance and output characteristics of Cat engines
  • Power Termination
    • Bus Bar
  • Governing System
    • Cat Electronic Governor (ADEM A4)
  • Control Panel
    • EMCP 4 Genset Controller
  • Lube System
    • Lubricating oil
    • Oil drain valves
  • Mounting
    • Rubber vibration isolators
  • Mounting System
    • Captive linear vibration isolators between base and engine-generator. includes lifting provisions and termination points for coolant and lube oil drain lines
  • Starting/Charging
    • 24 Volt battery with rack and cables
  • General
    • Engine and alternator pre-paint, Caterpillar yellow
  • Exhaust
    • Industrial, Residential, Critical Mufflers
  • Air Inlet System
    • Dual element air cleaner
    • Single element air cleaner
  • Circuit Breakers
    • 3 Pole (IEC-100% rated) circuit breakers - Motorised
    • 4 Pole (IEC-100% rated) circuit breakers - Motorised
    • Circuit breaker (IEC) auxiliary contacts
    • Pad-lockable circuit breaker device
    • 3 Pole (IEC-100% rated) circuit breakers - Package mounted
    • 4 Pole (IEC-100% rated) circuit breakers - Package mounted
    • Power terminal strip
    • Shunt trip for IEC breaker
  • Generator
    • Anti-condensation heater
    • Excitation: [ ] Permanent Magnet Excited (PM) [ ] Internally Excited (IE)
    • Oversize and premium generators
  • Power Termination
    • Circuit breakers, IEC compliant
    • Circuit breakers, UL listed
  • Control Panels
    • Local & remote annunciator modules
    • Load share module
    • Remote monitoring software
    • EMCP (4.2) (4.3) (4.4)
    • Digital I/O module
  • Control System
    • Oil temperature displays
    • EMCP 4.4
    • Volt free contact
    • Protective devices: Earth fault relay - earth leageage ground fault relay - Overload shutdown via breaker - Low fuel level alarm - Low fuel level shutdown - high fuel level alarm - Fuel level sensor
    • Local alarm modules
    • Remote annunciator modules
    • Local alarm horn
  • Cooling System
    • Low coolant temperature alarm
    • Radiator duct flange
  • Starting/Charging
    • Oversize batteries
    • Jacket water heater
    • Battery chargers
    • Heavy-duty starting system
    • Charging alternator
  • Enclosures
    • Sound attenuated enclosures
  • Exhaust System
    • Manifold and Turbocharger guard
    • Engine mounted muffler
    • 8 and 10 inch elbow kits
    • 8 and 10 inch GP flanges
    • 10, 25 and 35 end in / end out Mufflers
  • Fuel System
    • Integral - Duel wall fuel tank base
    • Manual fuel transfer pump
    • Fuel transfer system
  • Generator and Attachments
    • LC frame generator
    • Permanent magnet excitation
    • LC frame oversize generators
    • Space heaters
    • A frame oversize generator
    • A frame CIP generator
    • Ingress protection
    • LC frame CIP generator
  • General
    • Single or dual wall integral fuel tanks
    • UL 2200 package
    • Enclosures: sound attenuated, weather protective
    • EU Certificate of Conformance (CE)
    • Integral & sub-base UL listed dual wall fuel tanks
    • Narrow, Wide or Skid Base
    • The following options are based on regional and product configuration:
    • Seismic Certification per applicable building codes: IBC 2000, IBC 2003, IBC 2006, IBC 2009, CBC 2007
    • EEC Declaration of Conformity
    • CSA Certification
    • Sound attenuated, weather protective or high ambient weather protective enclosure
    • Automatic transfer switches (ATS)
    • Single or dual wall sub-base fuel tanks
  • Lube System
    • Manual sump pump
  • Starting and Charging
    • Jacket water heaters
    • 5 Amp battery charger
    • Battery disconnect switch