Offshore Drilling and Production Generator Sets
3508B Offshore Generator Set
-
Minimum Rating738 kV·A
-
Maximum Rating1138 kV·A
-
EmissionsIMO Tier I
-
AspirationTUrbocharged-Aftercooled
Engine Specifications
- Minimum Rating
- 738 kV·A
- Maximum Rating
- 1138 kV·A
- Emissions
- IMO Tier I
- Aspiration
- TUrbocharged-Aftercooled
- Fuel System
- EUI
- Oil Change Interval
- 1000.0 hr
- Stroke
- 7.5 in
- Bore
- 6.7 in
- Displacement
- 2116.0 in3
- Engine Control
- ADEM A3
- Weight
- 27503 lb
- Aspiration
- Turbocharged-Aftercooled
- Bore
- 6.7 in
- Displacement
- 2116 in³
- Fuel System
- EUI
- Oil Change Interval
- 1000 h
- Stroke
- 7.5 in
Dimensions
- Length
- 158.7 in
- Height
- 80.6 in
- Width
- 70.2 in
- Height
- 80.6 in
- Length
- 158.7 in
- Width
- 70.2 in
Capacity for Liquids
- Cooling System
- 81.6 gal
- Lube Oil System
- 60.0 gal
- Cooling System
- 81.6 gal (US)
- Lube Oil System
- 60 gal (US)
-
AIR INLET SYSTEM
- Separate Circuit aftercooler core, corrosion resistant coated(air side)Air cleaner, regular dutyDual Turbochargers, 152 mm (6 in) OD straight connection
-
CONTROL SYSTEM
- Caterpillar A-III Electronic Engine Control, LHwith Electronic Unit Injector Fuel SystemRigid Wiring Harness(10 amp DC power required to drive Electronic Engine Control Module)
-
COOLING SYSTEM
- Outlet controlled thermostat and housing, full opentemperature 92°C (198°F)
- Jacket water pump, gear driven
- Single water outlet connection, includes flange:143 mm (5.6")
- Aftercooler fresh water cooling pump (SCAC), gear drivencentrifugal
- SCAC pump circuit contains a thermostat to keep theaftercooler coolant from falling below 30°C (85°F)
-
EXHAUST SYSTEM
- Dry gas tight exhaust manifolds with heat shieldsDual Turbochargers with watercooled bearings and heat shieldsExhaust outlet, vertical, 203 mm (8 in) round flanged outlet
-
FLYWHEELS & FLYWHEEL HOUSINGS
- Flywheel, SAE No. 00, 183 teethFlywheel housing, SAE No. 00
-
FUEL SYSTEM
- Fuel filter
- Fuel transfer pump
- Electronically Controlled Unit Injectors
- Fuel priming pump, LH
- Rigid fuel return line with customer connection point asbase of engine
-
INSTRUMENTATION
- Overspeed shutdown notification light, Emergency stop notification light
- Graphical Unit (Marine Power Display) for analog or digital displayof:
-
LUBE SYSTEM
- Crankcase breather, top mounted
- Oil cooler
- Oil filter and dipstick, LH
- Oil pump, gear-type
- Oil pan drain valve, 2" NPT female connection
-
PROTECTION SYSTEM
- A-III Electronic Monitoring System provides customer programmableengine de-ration strategies to protect against adverse operatingconditions
- Emergency stop push button (located in Electronic Instrument Panel)Safety shutoff protection:
-
STARTING SYSTEM
- Air starting motor, RH, 620 to 1034 kPa (90 to 150 psi),LH control
- Air silencer
-
GENERAL
- Paint, Caterpillar yellow, with black rails
- Vibration damper and guard
- Lifting eyes
- Engine and generator, three-point mounted to sub-base
- Lift provisions on base
- Oil drain extension
- Engine length drip pan
-
AIR INLET SYSTEM
- Remote Air Inlet Adapters
-
CHARGING SYSTEM
- Battery Chargers
- Charging Alternators
-
CONTROL SYSTEM
- Load Sharing module
- Local speed throttle control
- Direct rack control interface, 0-200 mA DC control
-
COOLING SYSTEM
- Coolant level sensors
- Connections
- Air separator
-
EXHAUST SYSTEM
- Flexible fittings
- Elbows
- Flanges
- Flange and exhaust expanders
- Mufflers
-
FUEL SYSTEM
- Fuel Cooler
- Primary fuel filter
- Fuel filters
- Duplex fuel filters
- Fuel level switch
-
GENERATOR ATTACHMENTS
- Air filter — generator
- Bearing temperature detectors
- Cable access box
- Manual voltage control
-
INSTRUMENTATION
- PL1000T Communication Module
- PL1000E Communication Module
- Customer Interface Box
- Remote panel display
- Remote cylinder temperature display
- Exhaust temperature thermocouples
- Discrete I/O module
- Intake manifold temperature sensors
- Oil temperature sensor
-
LUBE SYSTEM
- Duplex oil filter
- Bypass centrifugal oil filter
- 500-hour oil pan
- Emergency lube oil connections
- Oil level regulator
- Prelube
- Sump pump
-
MOUNTING SYSTEM
- Vibration isolators
-
POWER TAKE-OFFS
- Auxiliary drive shafts and pulleys
-
STARTING SYSTEM
- Air or electric starting motor
- Redundant start with select switch
-
PROTECTION SYSTEM
- Spray shielding
- Crankcase explosion relief valve
- Metal particle detector
-
GENERAL
- Jacket water heater