C18 Marine Generator Set

masthead-innerpage-bg
Exterior View

C18 Marine Generator Set

Power Range260 – 565 ekW
Frequency50 / 60
Minimum Rating260 ekW (325 kVA)
Maximum Rating565 ekW (706 kVA)
product-tabs-bg

Learn more about our C18 Marine Generator Set

The C18 is the latest generator and brings commonality with our petroleum products as well as interfacing improvements. We have also taken this opportunity to add new price list options. All engine ratings and emissions certifications are the same, however we have been able to increase the power output of the generator for 12 of the 14 ratings.

Power Range
260 - 565 ekW
Frequency
50 / 60
Minimum Rating
260 ekW (325 kVA)
Maximum Rating
565 ekW (706 kVA)
Emissions
EPA Tier 3, IMO II, EU IWW, EU Stage V, China II
Configuration
In-line 6, 4-Stroke-Cycle Diesel
Aspiration
Turbocharged - Aftercooled
Bore
5.7in
Stroke
7.2in
Fuel System
MEUI
Oil Change Interval
250 / 500 hours
Governor
Electronic
Refill Capacity
68
Cooling
Heat Exchanger, Keel, Radiator Cooled
Rotation from Flywheel End
SAE No. (136 teeth)
Excitation
SRMP
Insulation
Class H
IP Rating
IP23 (standard), IP 44 (optional)
Voltage Regulator
CDVR (Digital Voltage)
Height
94.8in
Length
55.6in
Width
66.9in
Weight - Approximate
13396lb
Length
119.6in
Height
64.9in
Width
55.6in
Weight - Approximate
9747lb
Separate circuit after-cooled (SCAC)
Open Crankcase Ventilation (OCV) system
Turbocharger, jacket water cooled
Turbocharger inlet, 152 mm (6 in) OD straight connection
SCAC pump, gear driven, for HEX cooled engines only
Jacket water pump, gear driven
SCAC and JW shunt tanks for maintaining proper pump inlet pressures
Water-cooled exhaust manifold & turbocharger
Round flanged exhaust outlet
Hybrid fuel line design
Fuel transfer pump, gear driven
Front service simplex fuel system
Manual fuel priming pump
Center sump oil pan: Deep 500 hour oil change interval
Front and top service oil filler locations
Front service dipstick
Oil pump, gear driven
Vibration Isolators
Formed C-channel rails
Common Interface to all Genset Control Panels
Programmable Low Idle
Electronic Diagnostics and Fault Logging
Electronic Fuel/Air Ratio Control
Programmable ECM Shutdowns for: High Jacket Water Coolant Temp Low Engine Oil Pressure Engine Overspeed
Dry Elbows
Water-Cooled Elbows
Flexible Fitting
Flange
Muffler
Muffler, Spark Arresting
Air Inlet Adapter
Battery Chargers 10 amp
Charging alternator 24V 105 amp
Caterpillar alarm and protection
EMCP 4.2 control panel
MGCP III B control panel
Duplex fuel filter – front service
Fuel cooler
Primary fuel/water separator
Generator service side - LH, RH
Generator terminal box extension
Load sharing module (option for type approved module)
Duplex oil filter
Sump pump
Generator protection - IP44
Starting motors - electric and/or air
Jacket water heaters
TO TOP